Access Cover LOMAX
About
The LOMAX™ Hard Tri-Fold Cover maximizes your truck with a low profile design and maximum protection. This lightweight hard tonneau cover is designed for strength, security and style, while being easy to use and offering a simple one person installation and removal. This hard folding cover uses strong aluminum panels with durable, watertight, reinforced vinyl coated hinges. The panels are made from aluminum alloy used to make commercial trailers and coated with a textured matte black finish to perfectly complement your truck and OEM bed caps. Extruded aluminum channels under the panels keep the hard truck bed cover rigid while reducing weight. Flexible rubber seals, vinyl coated hinges and limited metal-on-metal contact all work together to reduce noise and vibration for a quiet ride.
Details
SLEEK, ULTRA LOW PROFILE DESIGN: Sitting less than half an inch above the truck bed, the textured matte black finish of LOMAX™ Hard Tri-Fold Cover blends with your truck’s OEM bed caps for a sharp, clean appearance.
EASY TO OPERATE: To open, pull cord from either side to release latches; folding each panel automatically disengages additional locks. Then, secure LOMAX™ Hard Tri-Fold Cover with integrated storage clips. To close, release storage clips and use built-in handle to unfold panels. The tonneau automatically locks at ten points when closed, keeping your cargo protected and out of sight
WEATHERTIGHT SEAL: The water-shedding design and waterproof, reinforced vinyl coated hinges route water away from the bed without gutters or drains. The hard folding tonneau overlaps the bed rails with a continuous seal along the entire length of the side rails, preventing elements from entering the truck bed.
STRONG YET LIGHTWEIGHT: Extruded aluminum channels support the panels to hold up to 400 pounds of evenly distributed weight, while weighing approximately 50 pounds for a high strength-to-weight ratio.
INTEGRATED STORAGE CLIPS: Sleek, retractable storage clips hold tonneau cover secure and vinyl capped rigid standoffs with rubber pads keep panels properly spaced in the folded position. No adjustments needed.
SIMPLE INSTALLATION: Install rails with eight TIGHT BITE™ Clamps. Slide the hard tonneau cover forward to engage hooks, then lower into retainment brackets. Unfold each panel, truck bed cover locks automatically at ten points when closed. No drilling required
EASY TO REMOVE AND REINSTALL: With LOMAX™ Cover open and storage clips secured, pull cord on front panel and slide it back to disengage hooks, then lift to remove. Reinstall by sliding tonneau cover forward to engage hooks, then lower into retainment brackets. This folding truck bed cover automatically locks in place.
